Panama Energy Agency Energy Storage Project

What is Panama's national energy plan 2015-2050?

To address these challenges, Panama’s National Energy Plan 2015-2050 has started moving the energy sector decisively towards a more diverse energy mix that takes full advantage of the country’s significant renewable energy resource potential. At the core of the plan is a massive scale-up of solar photovoltaic and wind energy.

Where can I study energy and Environmental Engineering in Panama?

These include the energy and environmental engineering course ofered by the Technological University of Panama (UTP) at the undergraduate, master’s and doctoral levels, and upcoming degrees at the University of Panama (UP) in electricity and renewable energy engineering.

What are the challenges facing Panama's energy sector?

Challenge: Planning will remain an important cross-cutting area for Panama’s energy sector, as planners must cope with rising variability and uncertainty from the envisaged high penetration of solar and wind generation through to 2050.

What are the energy-intensive industries in Panama?

Energy-intensive industries in Panama include food, tobacco, cement and paper production. Based on SNE (2015), Plan Energético Nacional (2015-2050). 4. COMMERCIAL AND PUBLIC SECTOR: The commercial and public sector is the largest consumer of electricity among the four sectors. Consumption reached 2 816 kboe in 2014 (Figure 5).

How much PV capacity does Panama have in 2023?

It said that if the review calls for changes to current legislation, it will make adjustments after extensive consultation with the electricity sector. According to the latest statistics from the International Renewable Energy Agency (IRENA), Panama had around 570 MW of installed PV capacity at the end of 2023.

What type of energy does Panama use?

Buildings in Panama use electricity for lighting, cooling, heating and motive power, while bunker fuel and diesel are used in boilers and furnaces to produce heat, and petroleum coke is used in cement plants. The use of oil products corresponds to more than 80% of the industrial sector’s total energy consumption (Figure 8).